Spray foam insulation is a great product, but if the coverage isn't uniform, the performance suffers. In this house in Charleston, South Carolina, a contractor who was doing his first spray foam job left the homeowner with a very lumpy installation and a hot attic. To read more about the performance of flat or lumpy insulation (http://hub.am/cBGCwO) or the 4 pitfalls of spray foam insulation (http://hub.am/bWe8Hy), go to the Energy Vanguard blog at blog.energyvanguard.com.

Views: 396

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Comment by Stan Kuhn on September 19, 2013 at 5:47pm

That looks better than 99% of the foam I've seen.  I did see ONE flash coat on walls that looked good.  The worst (so far) was a two-section, connected, roof where one section was foamed on the deck underside (much more lumpy than this video) and the other was left as original batts on the flat ceiling, and ventilated.  The homeowner figured out that something wasn't right about it, but the foam guy refused to return and correct it.  Happens to be one of the more "popular" ones in the area.  The word really needs to get out somehow about the ripoff that's occurring of unsuspecting homeowners.  And, I know that not all are thieves, but there are way too many running loose.  I haven't seen one job where the promised thickness was delivered consistently.

Comment by Greg La Vardera on September 19, 2013 at 7:36am

Sorry to say, but I've seen much worse sprayfoam installs. 

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
5 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
6 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
8 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
9 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
10 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
11 hours ago
Lars olsen posted a blog post
19 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service