Phil Luther's Blog (3)

The Great Water Heater Temperature Setting Debate

Much has been discussed over exactly what is an optimal water heater temperature level setting. Many sources, consisting of ENERGY STAR, offer the energy conserving elements of temperature levels of 120 degrees or lower. And yes, there are cost savings to be had, however realistically for those whose current setting is closer to the standard factory preset temperature of 140 degrees.…

Continue

Added by Phil Luther on February 27, 2014 at 12:00pm — 2 Comments

Water Heater Maintenance in 10 Minutes

I just put together a new infographic on the best two maintenance tasks homeowners can do with their water heaters.  The best part is that they only take about ten minutes or so to perform!  By checking these two things at least once a year will help with getting the full life out of ones water heater, as well as making it as energy efficient as possible.

Enjoy!

10 Minute Water Heater Maintenance

Explore more…
Continue

Added by Phil Luther on February 25, 2014 at 10:54am — No Comments

Water Heater Maintenance Tips

I wanted to share an infographic I put together on the importance of water heater safety and the maintenance tasks most homeowners should be able to do to monitor their water heaters. Enjoy!…

Continue

Added by Phil Luther on February 17, 2014 at 8:38pm — No Comments

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Mariusz Chorazy posted a blog post

Here are a few tips to keep your air conditioning bill low

TAKE GOOD CARE OF YOUR AIR CONDITIONER – Like any major appliance, your AC requires regular…See More
yesterday
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Morgan, I got this below from the Knight installation manual. I note a few things, -These…"
yesterday
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
yesterday
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
yesterday
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
yesterday
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
yesterday
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
yesterday
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
Friday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service