David Valley's Blog – December 2010 Archive (2)

Enhancing Your Infrared (Thermal) Imaging Scan

Wouldn't it be nice to have all your sites fully prepared for you before you arrive for an infrared scan? It can be possible if you politely ask your clients to have the home (or job site) prepared for you in order to alleviate any issues during the thermal scan. With the many unprepared infrared scans that I have completed, I have come up with a list in order for you to achieve the maximum benefit of your infrared inspections....

 

• Plan optimal times of day for your infrared…

Continue

Added by David Valley on December 17, 2010 at 8:00am — 2 Comments

Infrared Detects Piping Issues Behind Walls

pipe leaks

The problem faced by most property owners is that any moisture behind the walls, over ceilings, and under the floors are often impossible to detect until the problem is excessive and obviously visible. But, by then it’s too late and all damaged surfaces must now be replaced, along with the pipes that caused the damage. Small supply pipe leaks or waste line seepage's are common sources of water…

Continue

Added by David Valley on December 9, 2010 at 9:00am — No Comments

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
33 minutes ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
1 hour ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
2 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
3 hours ago
Lars olsen posted a blog post
11 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
21 hours ago
Hans Joachim Preiss replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Good discussion. I came across this comprehensive presentation by Gas Consultants on the effects at…"
22 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Excellent reply Hans. I think that there isnt' a good general answer to this question but that…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service