Touch 'n Seal FireStop 814 Caulk

Touch ‘n Seal FireStop 814 is a UL classified, one part, elastomeric, intumescent firestop caulk that meets or exceeds the requirements of ASTM E-814 (UL 1479).

FireStop 814 bonds to almost any traditional building surface, including wood, concrete, gypsum board, fiberboard, and metal. When used in wood and concrete assemblies, FireStop 814 is an approved through-penetration sealant for use around HVAC ducting; metal and plastic pipes; electrical and communications wire or other cabling.

Views: 113

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Forum Discussions

Investigating 3257KWH monthly usage issue.

Started by Brent Shapiro in General Forum. Last reply by John Nicholas 1 hour ago. 6 Replies

Earn 2 BPI CEUs by Blogging for BPI

Started by Quinn Korzeniecki in General Forum on Monday. 0 Replies

What made this chimney fall down?

Started by Eric Kjelshus in General Forum. Last reply by Eric Kjelshus Jun 15. 5 Replies

Studies on Home Energy Audit Energy Savings Potential?

Started by Julie Saporito in General Forum. Last reply by Danielle Sass Byrnett Jun 15. 5 Replies

Latest Activity

John Nicholas replied to Brent Shapiro's discussion Investigating 3257KWH monthly usage issue.
"Check out the DHW unit.  What temperature is the water entering and leaving the unit?…"
1 hour ago
Brent Shapiro replied to Brent Shapiro's discussion Investigating 3257KWH monthly usage issue.
"With regard to the outside lighting - zero outside lighting, in fact the lighting in the basement…"
3 hours ago
Green ID posted blog posts
3 hours ago
Rob Buchanan posted a discussion

Building envelope and mechanical interactive effects

Good afternoon everyone,I was reviewing some of the old BPI newsletters and noticed a…See More
7 hours ago

Photos

Loading…
  • Add Photos
  • View All

© 2017   Created by Lawrence Berkeley National Laboratory.   Powered by

Badges  |  Report an Issue  |  Terms of Service