weatherstripping-zen

The best-intentioned weatherstripping was too ambitious and one had to be too macho in order to close the patio doors. They wouldn't even lock.... Out it came.... Kermit is beaten, but not defeated....

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Comment by Evan Mills on December 8, 2010 at 5:27pm
Debra - thanks for your generous info and insights on the flooring. Yes, humidity is >80% a lot of the time..... Moisture measurements on the floor surface facing the crawlspace (2x6 original T&G redwood which is under the bamboo, along with felt and 1/4" ply to level things off) were a few %-points above those in the flooring from the living space. We installed a continuous vapor barrier on the ground (yes, we may do a conditioned crawlspace ... not sure yet). Still have the cupping.
Comment by Debra Monte on December 8, 2010 at 3:00pm
Evan, I read the article and didn't see anything with regard to the flooring except that you do live in a humid area. Bamboo is very forgiving and stable, which allows it to be in high humidity. However, when the humidity levels are very high and or there are moisture problems or leaks, the cupping will appear. The good thing is that once the moisture or humidity problems are remediated, the bamboo will eventually lay totally flat and even again.

I experienced this myself. I moved into a fairly new home in 2008, where the previous owner only resided there for 7 years (first owner) and there was wall to wall carpeting throughout the house with the exception of the kitchen that had a vinyl flooring adhered to 1/4 inch thick Luan board, which was stapled with a miillion staples to the subfloor. Beneath the carpeting was only OSB sub-floor.

Of course, I wanted to also be green and installed 4 inch strand bamboo planks throughout the house, including the kitchen, over a thick multi-fiber insulayment. The baseboards were also strand bamboo, they cost a bit. My daughter's room was the only room where we installed a windsor oak plank.

About a year after the floor was installed, my daughter asked me to come and investigate a hissing sound coming from near the refigerator, which is in close proximity to the range. I didn't smell any gas and then decided to move the refrigerator out to inspect further and found that the cold water supply line to the rear of the refrigerator had sprouted a small leak that was continuously coming out behind the refigerator. The line was not made of copper, unfortunately it was just a cheap plastic line, sort of like a straw. Fortunately, there was a separate shut off valve under the sink and I did close it. No more cubes for now....

Of course, after wiping up what I could see, the floor eventually started to cup in the area in front of and around the refrigerator. This did not make me happy. However, after it was fully dried, perhaps a couple of weeks, the floor was back to normal with no cupping and no lasting damage.

Recently, we had the wonderful builder's grade toilet on the second floor overflow and somehow continuously shoot water out. Once I stopped it and wiped everything up, water had gone out of the bathroom into the hallway and soaked through to parts of the ceiling below. Within a few days the floor began to cup. This happened last week and I am hopeful that with a few weeks or so, it will go back to its normal condition.

So, find the source of all the moisture, repair/remediate and give the bamboo a little time to back into shape.
Good luck.
Comment by Mark Richardson on December 8, 2010 at 9:16am
Isn't that the Cantonese hyroglyph for "Distress?"
Comment by Evan Mills on December 7, 2010 at 8:22pm
Actually, the flooring is cupping (manufacturer blaming contractor and visa versa).... Kermit was right!
Comment by Debra Monte on December 7, 2010 at 8:11pm
Nice strand bamboo flooring though....

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

Kurt Shafer replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Reading the Invisco description you will find that it is designed to be surrounded by cellulose to…"
16 hours ago
Glen Gallo replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Kurt, I think cost of operation is always a factor but I am not sure I would leave it just cfm.…"
16 hours ago

Paul DelVaglio just added their location.
(via Member Map)

18 hours ago
Paul DelVaglio posted a photo
18 hours ago
reflintorm replied to Jamie Kaye's discussion Flickering LED lights
"I think, Better to replace the dimmer switch if it is not recovered then once go through the…"
22 hours ago
Kurt Shafer replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Glen,  You are the first person who has ever told me they prefer lower CFM. What you left out…"
yesterday
Glen Gallo replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Tamarack has lower CFM than typical fans and has a insulated lid that automatically closes when fan…"
yesterday
Tom Conlon's discussion was featured

Whole House Fans - Love 'Em or Not?

I just searched this forum for "Whole House Fan", but I didn't find much about them (except …See More
yesterday
Tom White shared Brandon Walton's blog post on Twitter
yesterday
Brandon Walton's blog post was featured

12 Things Every Home Performance Contractor Should Have on Their Work Truck

Every home is unique and differs from the last. It would be a perfect world (from a project…See More
yesterday
Griffin Hagle replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
yesterday
Griffin Hagle replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Kurt, Whoops, looks like I got my links mixed up. Thanks for pointing that out. Here's the…"
yesterday

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service