This is here to point out the total lack of recognition of heat-transfer, we just patch up the problem with some insulation here, some vapor barrier there.
Tags: Architecture, Autonomous, foundation, heat-loss
Albums: Autonomous Architecture
Location: Seattle, WA
Comment
Comment by Tom Mallard on March 28, 2011 at 8:02am The foundation is hard to control for heat-transfer due the compression loads, can't say I've solved anything other than to ponder insulation that can handle the loads to replace the board joists are usually nailed that's anchored to the concrete. That would be a worthy new product for energy conservation in home construction.
Another I've thought of tho' is where joists are open to the interior floor, that first foot needs to breathe but my opinion needs to be stuffed with insulation with the paper torn off to allow breathing of condensation but killing direct air movement.
That area is like a chiller in winter, the cold air from the wood gets warmed enough right there to rise and creep along the floor above the typical insulation just from sag between it and the wood!!
Comment by Tom Mallard on March 28, 2011 at 6:03am
Comment by Jim Peck on March 28, 2011 at 3:50am Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
David Eakin commented on Elisa Wood's blog post Momentum builds for energy efficiency...but is the wolf at the door?
Egr renovation posted a status
Egr renovation posted a status
Meagan Foster posted events
Meagan Foster updated an event
Meagan Foster updated an event
Meagan Foster updated an event
Meagan Foster updated an event© 2013 Created by Lawrence Berkeley National Laboratory.
You need to be a member of Home Energy Pros to add comments!
Join Home Energy Pros