Foundation Thermal Sketch

This is here to point out the total lack of recognition of heat-transfer, we just patch up the problem with some insulation here, some vapor barrier there.

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Comment by Tom Mallard on March 28, 2011 at 8:02am

The foundation is hard to control for heat-transfer due the compression loads, can't say I've solved anything other than to ponder insulation that can handle the loads to replace the board joists are usually nailed that's anchored to the concrete. That would be a worthy new product for energy conservation in home construction.

Another I've thought of tho' is where joists are open to the interior floor, that first foot needs to breathe but my opinion needs to be stuffed with insulation with the paper torn off to allow breathing of condensation but killing direct air movement.

That area is like a chiller in winter, the cold air from the wood gets warmed enough right there to rise and creep along the floor above the typical insulation just from sag between it and the wood!!

Comment by Tom Mallard on March 28, 2011 at 6:03am
Too true ... I'm such a misfit ...
Comment by Jim Peck on March 28, 2011 at 3:50am
As specie whom claims such intelligence, we do seem remarkably shortsighted

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

peter chang replied to peter chang's discussion Programmable tstat for electric baseboard?
"Yes, in fact I did just that for my kitchen toe-kick heater because the original thermostat was on…"
2 hours ago
Bob Blanchette replied to peter chang's discussion Programmable tstat for electric baseboard?
"Savings depends a LOT on how it's programmed. I've even done a setup with a contactor,…"
8 hours ago
Bob Blanchette replied to Hal Skinner's discussion Any success getting landlords to energy upgrade a single family rental unit?
"Sell utility subsidized services to the tenants. It has to pay back within a year though."
8 hours ago
Tom Mallard replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"Thx, Robert. Being a PNWester where crawl spaces are moist or wet seasonally & some sites never…"
12 hours ago
Hal Skinner added a discussion to the group The RCC Classroom (Radiant Control Coatings)
12 hours ago
Hal Skinner replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"I can only speak for the one I have worked with over t6he years.  We have a certification for…"
12 hours ago
Chad Mcaulife replied to Chad Mcaulife's discussion BPI QCI Cert.
"Thanks for the reponses.  I have a 40 hr class staring 12-8-2014 which should prepare me for…"
12 hours ago
Hal Skinner replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"Hi George, I can see where this could be a HUGE issue in Canada.   We spray our RCC directly…"
14 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service