weatherstripping-zen

The best-intentioned weatherstripping was too ambitious and one had to be too macho in order to close the patio doors. They wouldn't even lock.... Out it came.... Kermit is beaten, but not defeated....

Views: 135

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Comment by Evan Mills on December 8, 2010 at 5:27pm
Debra - thanks for your generous info and insights on the flooring. Yes, humidity is >80% a lot of the time..... Moisture measurements on the floor surface facing the crawlspace (2x6 original T&G redwood which is under the bamboo, along with felt and 1/4" ply to level things off) were a few %-points above those in the flooring from the living space. We installed a continuous vapor barrier on the ground (yes, we may do a conditioned crawlspace ... not sure yet). Still have the cupping.
Comment by Debra Monte on December 8, 2010 at 3:00pm
Evan, I read the article and didn't see anything with regard to the flooring except that you do live in a humid area. Bamboo is very forgiving and stable, which allows it to be in high humidity. However, when the humidity levels are very high and or there are moisture problems or leaks, the cupping will appear. The good thing is that once the moisture or humidity problems are remediated, the bamboo will eventually lay totally flat and even again.

I experienced this myself. I moved into a fairly new home in 2008, where the previous owner only resided there for 7 years (first owner) and there was wall to wall carpeting throughout the house with the exception of the kitchen that had a vinyl flooring adhered to 1/4 inch thick Luan board, which was stapled with a miillion staples to the subfloor. Beneath the carpeting was only OSB sub-floor.

Of course, I wanted to also be green and installed 4 inch strand bamboo planks throughout the house, including the kitchen, over a thick multi-fiber insulayment. The baseboards were also strand bamboo, they cost a bit. My daughter's room was the only room where we installed a windsor oak plank.

About a year after the floor was installed, my daughter asked me to come and investigate a hissing sound coming from near the refigerator, which is in close proximity to the range. I didn't smell any gas and then decided to move the refrigerator out to inspect further and found that the cold water supply line to the rear of the refrigerator had sprouted a small leak that was continuously coming out behind the refigerator. The line was not made of copper, unfortunately it was just a cheap plastic line, sort of like a straw. Fortunately, there was a separate shut off valve under the sink and I did close it. No more cubes for now....

Of course, after wiping up what I could see, the floor eventually started to cup in the area in front of and around the refrigerator. This did not make me happy. However, after it was fully dried, perhaps a couple of weeks, the floor was back to normal with no cupping and no lasting damage.

Recently, we had the wonderful builder's grade toilet on the second floor overflow and somehow continuously shoot water out. Once I stopped it and wiped everything up, water had gone out of the bathroom into the hallway and soaked through to parts of the ceiling below. Within a few days the floor began to cup. This happened last week and I am hopeful that with a few weeks or so, it will go back to its normal condition.

So, find the source of all the moisture, repair/remediate and give the bamboo a little time to back into shape.
Good luck.
Comment by Mark Richardson on December 8, 2010 at 9:16am
Isn't that the Cantonese hyroglyph for "Distress?"
Comment by Evan Mills on December 7, 2010 at 8:22pm
Actually, the flooring is cupping (manufacturer blaming contractor and visa versa).... Kermit was right!
Comment by Debra Monte on December 7, 2010 at 8:11pm
Nice strand bamboo flooring though....

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Bachi Brunato joined Kyle Brown's group
Thumbnail

Wrightsoft - Manual J / Manual D

If you use Wrightsoft to calculate loads or design ducts, you likely have questions.  Get answers…See More
3 hours ago
Colin Genge commented on Greg Labbe's blog post Technical Tape Desecration
"i don't have a picture of it, but my Honda Accord's windshield was replaced and it leaked…"
8 hours ago
terry nordbye replied to Jim Gunshinan's discussion PHIUS+2015 Climate-Specific Passive Building Standard
"Both standards are good. Both standards win. PHI knows how to build a PH in the USA. The very…"
12 hours ago
Greg Labbe replied to Jim Gunshinan's discussion PHIUS+2015 Climate-Specific Passive Building Standard
""It’s important to note that the PHIUS+ 2015 metric is an optimization of the European…"
12 hours ago
Melissa Ulbricht posted a blog post
12 hours ago
David M Cohen added a discussion to the group Job Board
14 hours ago
David M Cohen joined Diane Chojnowski's group
Thumbnail

Job Board

This group is for posting jobs related to all aspects of the home performance industry including…See More
14 hours ago
Profile IconSarah Mostafa, Michael Kelemen, Sean Maxwell and 3 more joined Home Energy Pros
14 hours ago

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service