custom_solar_screen

Sometimes, getting creative can save energy. Custom solar screen.

Views: 159

Comment

You need to be a member of Home Energy Pros to add comments!

Join Home Energy Pros

Comment by Dennis Cheslik on September 10, 2012 at 12:24pm

In response to your question, Bob: The picture is a bit misleading, there is a 12 inch gap between the AC unit and the screen. Plenty of space to keep the unit well ventilated. Also, the unit faces towards the west, and 90% of the time, here in texas, the wind blows from the south between the screen and the unit.

Comment by Bob Blanchette on September 9, 2012 at 6:27pm

Does the screen cause any recirculation of condenser discharge air?

Comment by Tom DelConte on August 6, 2012 at 6:06am

I like it. A lot of these 80's saving tricks have been forgotten due to excess complication, or an havc guy taking them down, but many are still viable today. It always helps you at parties, too, if people think you're a home energy, or even whiskey 'stilling eccentric!

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
6 minutes ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
54 minutes ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
1 hour ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
3 hours ago
Lars olsen posted a blog post
10 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
21 hours ago
Hans Joachim Preiss replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Good discussion. I came across this comprehensive presentation by Gas Consultants on the effects at…"
22 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Excellent reply Hans. I think that there isnt' a good general answer to this question but that…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service