Information

TREAT Software

A forum to discuss how to questions regarding modeling issues, improvements, etc.

Members: 20
Latest Activity: Feb 24

Discussion Forum

Modeling the apartment upstairs 1 Reply

Greetings everyone,   I have a strange scenario to model and I was hoping I could get some advice: This used to be a whole building built on 1,920 so it is a balloon framing. The homeowner' s…Continue

Started by Luis Hernandez. Last reply by John Watson Ley Feb 24.

Modeling a Townhouse 4 Replies

Hi everyone!      I am learning TREAT, so perhaps this is too simple of a question for you guys but I am kind of stuck... when TREAT asked me about the building I choose attached, considering that…Continue

Started by Luis Hernandez. Last reply by Luis Hernandez Jul 7, 2013.

Modeling attics slopes for foam. 4 Replies

How are attic slopes modeled for foam insulation. When ever I've added a foamed slope I get a very low SIR with virtually no savings. What am I doing wrong?ThanksContinue

Started by Paul Lasicki. Last reply by tedkidd Aug 23, 2012.

Improvement Question 5 Replies

A client has an old gas fired boiler with a gas fired storage tank DHW. I'm looking to replace both units with a high efficiency gas fired boiler 2 pipe direct vent seal combustion unit with indirect…Continue

Started by Paul Lasicki. Last reply by randy tolowski Mar 21, 2012.

Comment Wall

Comment

You need to be a member of TREAT Software to add comments!

Comment by Jan E. Graveamker on February 23, 2012 at 9:40am

Electric baseboard or electric in wall (can) heaters,

is there a way in TREAT to replace more than 1 line voltage thermostat ( non rpgrammable) and get a result.

 

 

Greetings Jan   

 

Members (18)

 
 
 

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

Hal Skinner replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"I found the buildingscience article interesting.  Interesting that they noted the wet bottom…"
18 minutes ago
Bud Poll replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"With conduction that ends at the bottom of the joists and convection that is naturally suppressed…"
1 hour ago
Hal Skinner replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"Good morning Bud, Took a quick look at the site and a couple others listed on the Yahoo…"
3 hours ago
Bud Poll replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"Hi Hal, Search "Basecalc basement heat loss".  From memory Canada (nrcan) has/had a…"
4 hours ago
Michael Dunseith posted photos
17 hours ago
Hal Skinner replied to Hal Skinner's discussion How much heat energy is lost through the floor of a house?
"II just remembered seeing a report by a federal adency, many years ago, that basically said …"
20 hours ago
Don Fitchett commented on Tom White's video
Thumbnail

Alliant Energy's PowerHouse TV: Sealing Leaky Ductwork

"Very educational. thanks for sharing Tom."
23 hours ago
Hal Skinner posted a discussion

How much heat energy is lost through the floor of a house?

I am asking this as I do not recall anyone speaking of any study to this end.  Many comments about…See More
23 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service