Where to find EER and SEER if it is not on the label

That's all

Judi

Views: 370

Replies to This Discussion

You will have to access the manufacturers information or you can use a Prestons Guide that will give basic ( and I do mean basic) information as to the date of manufacture and rated eff for that model condensor.  It will not show eff for condensors installed to old coils or the eff of an older unit installed to a TXV coil.  Preston's guide doesnt show any information reguarding cond & evap coil matchups.

 

 You can also try the AHRINET.ORG web site  They are the organization that certifies the efficiency and capacity of a/c's, ht pumps and such.  If you have the condensor, evap coil & furnace model #'s you can get a certified rating for that combination.  We print that off for all our customers so they know they are getting what they paid for.

I haven't used it to find older equipment so I do not know if that is possible or not.  After I finish this I will try it and let you know if it works

I tried the AHRI site to look for older units and It doesnt work for units that are no longer in production and stock is no longer available.

Older equipment is more affected by it's condition than it's original SEER. Clean coils/blower, proper charge, and good ductwork can have that older 10SEER unit actually getting it's full 10 SEER. However that usually isn't the case, most older units are full of dirt, incorrectly charged, and have poor ductwork...

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
6 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
6 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
8 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
9 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
10 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
11 hours ago
Lars olsen posted a blog post
19 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service