Kari Sauder's Discussions (76)

Discussions Replied To (20) Replies Latest Activity

"Amen! -- you can say that again."

Kari Sauder replied Jan 18, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"the "white rust" was on the inside of the foil dryer "slinky" hose that is shown in…"

Kari Sauder replied Jan 18, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"It's all better now.  It's sitting plumb with glued PVC venting and the gas line is…"

Kari Sauder replied Jan 13, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"I'm seriously considering tracking down the whole house home inspector in this case…"

Kari Sauder replied Jan 13, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"As far as seismic activity -- this is PA not CA so no WH's have hold downs here...I…"

Kari Sauder replied Jan 5, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

""Not on his red list" was a direct quote from the new homeowner."

Kari Sauder replied Jan 3, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"Notice the duct tape around to protect the WH's finish from the strap which --- woul…"

Kari Sauder replied Jan 3, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"Sorry for the lack of focus -- new camera -- It's sitting on pavers on the right sid…"

Kari Sauder replied Jan 3, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

""

Kari Sauder replied Jan 3, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

"Are they actually doing a code insp. when they are there??  We do whole house reno's…"

Kari Sauder replied Jan 3, 2014 to Easy Water Heater Venting

22 Oct 23, 2014
Reply by Matthew Lutz

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
9 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
9 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
12 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
12 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
13 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
15 hours ago
Lars olsen posted a blog post
22 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service