I am involved in a QC program that straddles two of the four zones BPI uses to identify LBL "N" factors. Has anyone ever seen a map with enough resolution that could help determine whether a project lands in one zone or another? My area of concern is the division between zones 3 and 4 in southern California.  

Has anyone correlated the LBL N-factor zones with California Energy Commission climate zones?

With a requirement to meet ASHRAE standards, the 15% factor difference between zones could be significant.

Views: 1187

Replies to This Discussion

If you are in doubt, just use the middle value common to both zone 3 and 4:  23. 

 

The whole formula isn't all that precise anyways.  The N factors for each zone are a range of four numbers - that should tell you something.  Using the lower number will allow you to seal up a house tighter without having to do ASHRAE 1989.   But to meet ASHARE 62.2 - 2010, you probably have to install some kind of ventilation anyways - the only question is what cfm rate to set the fan at.

 

If you want to be more precise, use ASTM 779 and ASHRAE Standards 119 and 136 to calculate your own N factor instead of using that burry map.

 

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

Tom Conlon commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"I just checked the site Guidelines Kurt, and any true "promotions" should be posted in…"
12 hours ago
Tom Conlon posted a discussion

Whole House Fans - Love 'Em or Not?

I just searched this forum for "Whole House Fan", but I didn't find much about them (except …See More
12 hours ago
Richard Beyer replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"Don, Thank you for the praise! I only wish that some of these profiteers could answer my questions…"
15 hours ago
Richard Beyer replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"Todd, This report (attached link) below on poor people living in subsidized housing show's…"
15 hours ago
Mike Kandel added 4 discussions to the group Building Performance Institute (BPI)
17 hours ago
Mike Kandel posted discussions
17 hours ago
Nate Adams commented on Jim Gunshinan's blog post My Energy Upgrade California—The Numbers Are In
"Jim, Glad to help! OK, a touch of soap box. So long as we don't tell people EE is free and…"
17 hours ago
Kurt Shafer commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Bob, Good idea. I see that you are a window energy reduction expert. You might consider adding…"
18 hours ago
Robert (Bob) Bacon commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Kurt, I would explain what energy/efficiency problem this device solves and explain the science the…"
18 hours ago
Ben Jacobs replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"I agree that in many homes the indoor air sucks.  However, a lot of this problem is caused…"
20 hours ago
Kurt Shafer commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Tom, thank you for your odd reference to a leaky duck. It is a bit off topic since I was not asking…"
21 hours ago
Tom Delconte commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Shameless self promotion here sucks like a leaky duck!"
22 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service