The infrared image below (left) was taken by Jerritt Gluck of Bonded Building & Engineering. The concrete slab (right) had recently been drilled by a steel contractor, after which the following occurred. What is wrong with this picture, and what's the solution? What steps should the contractor and installation crew have taken to avoid this?
Tags: BPI, Chump, July, Stump, the
Permalink Reply by Isaac Savage on July 13, 2012 at 11:32am Looks like a hot water leak to me. Best to use that IR camera before you drill!
I agree with Issac but I will add that it may also be a steam line penetration. Were these photos taken in NYC?
Permalink Reply by Ed Minch on July 19, 2012 at 8:08am Hard to tell, house or commercial wold be good information - looks like a narrow band of warm ending in a large area of warm. Follow the narrow band back towards you to see what pipe disappears into the slab. Find the other end of that narrow warm going away from you to see where that end goes. Is it a sewer that was punctured and they just took a hot bath? Is it a DHW line that was punctured and is now leaking? And that steam idea ain't bad in the right setting.
Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
Patrick Michaelyan replied to Patrick Michaelyan's discussion Hot Upper Stories
Ed Minch replied to Patrick Michaelyan's discussion Hot Upper Stories
Craig Savage commented on Craig Savage's video
Tom Delconte commented on Craig Savage's video
Ben Jacobs replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
Craig Savage commented on Craig Savage's video
Tom Delconte commented on Craig Savage's video
Cory Chovanec replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
Jon Haehnel replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
Tom Smith replied to Patrick Michaelyan's discussion Hot Upper Stories
John Rising replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans© 2013 Created by Lawrence Berkeley National Laboratory.