What to do with a pocket door

Replies to This Discussion

Permalink Reply by Joseph Lamy on March 1, 2012 at 8:13am

If the cavity for the pocket door was constructed as many were - open to the exterior walls, then here's a fix: Slide the pocket door out, measure it, poke your tape measure into the cavity to determine how much room you have between the exterior wall and the outer edge of the door when it is wide open (i.e. pushed back into its slot).

Then if you have the room, slice off a fitting piece of blueboard or similar extruded polystyrene foam board insulation wide enough to fill the cavity where the doors are, poke it into place where the carpenters back in the day left the exterior open to the pocket door slot, and then with caulk, seal the edges. If the Blower Door retest indicates still more flow after this exercise, then it's the top plate or crawl space that will need your air-sealing expertise. This way you can get the most likely culprit, the wall connection, while standing up. Later you may HAFF to get dirty chasing down the attic/crawl connections.

• ‹ Previous
• 1
• 2
• Next ›
• Page