Had our furnace and air ducts cleaned today for the first time in years; could have spun an entire dog from all the embedded hair.  The serviceman tried to upsell me with both a new reusable filter (to get 94% of the airborne substances), and a UV light to be installed in the furnace to get the other 6% worth of mold spores, bacteria and no-seeums.  I bought the filter and also a thorough cleaning of the furnace, but am waiting to decide on the UV light--another $400--until I can determine if this will really improve our indoor air quality.  The house is 1000 sq ft, one dog and two dogwalkers live there.  Any opinions?  One dogwalker (me) has asthma.  I couldn't find any research from a casual googling.

Views: 49424

Reply to This

Replies to This Discussion

UV lights have their place - but in my opinion are ridiculously oversold.  In order to do ANYTHING worthwhile they MUST shine directly on the evaporator coil / drain pan.  Any other location and they do nothing useful.  Only when the shine on the evaporator coil do they have a long enough exposure time to reduce mold and such.

If the UV light is expected to kill mold spores as they fly past in the return duct - it will NEVER happen.  the total dose in the fraction of a second the mold passes thru the light is way to small to damage the mold in any way.  And as far as "killing" mold spores - those are the toughest, most well protected life stage of mold.  It can survive for decades in harsh environments and still be viable.  Why would spores be 'killed' by a fraction of a second of UV?  If that were to happen, then non-metal ducts would not survive the UV light.

I bought the UV lights and found myself replacing the expensive bulbs way more often than one would expect.  I do not recommend the UV component unless there were a realistic possibility that it "might" (emphasize "MIGHT") be of some benefit to an extremely infirm occupant whose doctor recommends such equipment.  Our houses are not hospital isolation wards . . . not even if there is an asthmatic occupant. 

Still, ducts do need to be cleaned periodically.  It's not clear to me why anybody is surprised to learn this to be the case.  The insides of the ducts are inside your house every bit as much as the living room rug.  Vacuuming the rug the does not involve shining an ultraviolet light on the floor.

I did use the 4" pleated filter but went back to a more conventional "rock catcher." The high-MERV filters collect smaller and smaller particles and thus may disturb the air flow and compromise the life of the furnace by making the fan work more than it may have been engineered for and by allowing the heat exchanger to expand excessively because of overheating. 

Don't do UV.

Grab a MERV 13 from filtersfast or something.


Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Ben Haas replied to Rod Fox's discussion Utility Meter Accuracy
"Yup..... 1200 amp service to the compound.....  3 -400 amp panels, all single phase since 3…"
4 hours ago
Walter Ahlgrim replied to Rod Fox's discussion Utility Meter Accuracy
"The more I think about it if the problem cannot be the current transformers reading small loads,…"
9 hours ago
Dennis Heidner replied to Rod Fox's discussion Utility Meter Accuracy
"Note to readers 0.5A instead of 5A for reading with A/D.... the edit to correct that didn't…"
10 hours ago
Dennis Heidner replied to Rod Fox's discussion Utility Meter Accuracy
"Rod, I have some of the CT's that you referenced in the openenergymonitor system.  They…"
10 hours ago
Tauran Ivall replied to Tauran Ivall's discussion Energy Efficient Entry Door options out there?
"Graham, How did this Plasproinc door cost?  Do you have any photos you can share a link to?"
11 hours ago
Dennis Heidner replied to Rod Fox's discussion Utility Meter Accuracy
"1200A service... really?  or did you mean 200A.  That size service would likely result in…"
12 hours ago
tedkidd replied to Rod Fox's discussion Utility Meter Accuracy
"That's great news! Guess that means there are a bunch of blower doors getting used in Jackson…"
13 hours ago
Ben Haas replied to Rod Fox's discussion Utility Meter Accuracy
"Teton County and the Town of Jackson Adopted the 2014 IRC energy code.... With that, inspectors now…"
13 hours ago

© 2015   Created by Lawrence Berkeley National Laboratory.   Powered by

Badges  |  Report an Issue  |  Terms of Service