Proper means to "plug" flue pipes after testing gas appliances.
I have seen metal "plugs" (and this may not be the correct term) used for the holes that are drilled in vent pipes, in order to test combustion appliances.
I'm referring to the type 1 vent pipe that is standard for atmospherically-vented gas appliances.
These plugs appear to be superior to HVAC foil tape. Any thoughts on this?
Also, does anybody know how to get their hands on these metal plugs? I use a 5/16" bit to drill probe holes.
Thanks in advance!
Views: 1090
Replies to This Discussion
-
Permalink Reply by Eric Lowry on -
I use furnace cement. Up to 3000 degree tolerance, inexpensive and easy to apply. I carry a small jar with an applicator inside.
I like to leave things as close to the way I found them.
- ‹ Previous
- 1
- 2
- 3
- Next ›
Home Energy Pros
Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
Latest Activity
Mark Richardson replied to J.C. Martel's discussion Disasters & sustainable energy
Eric Kjelshus replied to Johnny Ritzo's discussion Selecting a Water HeaterBachi Brunato replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT CansBachi Brunato's discussion was featuredBoxing and Insulating Around Non-ICAT Cans
Johnny Ritzo's discussion was featuredSelecting a Water Heater
George Kopf's discussion was featuredMisting Aeroseal in Pressurized Home = Amazing Air Sealing Innovation
Tom Delconte's blog post was featuredThe Surroundings Are Comprised of (fill in the blank) !
Christopher Morin's blog post was featuredSelling with Rebates: The Simple Payback
Mike Rogers's blog post was featuredHOMES Act introduced with Bi-Partisan Sponsorship
Mike Rogers posted a blog postHOMES Act introduced with Bi-Partisan Sponsorship
© 2013 Created by Lawrence Berkeley National Laboratory.
