I am working, doing audits, with a contractor who tends to make basements, crawlspaces into conditioned space. Especially when all or most of the duct work is in the crawlspace. He does this by covering the floor, side walls and piers with heavy plastic. He then uses rigid foam insulation on the walls, foams the joints and above and seals the vents and access hatches. Then we duct seal and re-insulate.

Has anyone been doing this for a while? Any unentended consquences?

Views: 1374

Reply to This

Replies to This Discussion

Be sure plastic is protected from mechanical damage by any future workers or residents accessing crawl space

Be sure to leave exposed strip for termite inspection. If termite bond is in place, be sure they are on board with details of the project - termites can tunnel, unnoticed through foam.

Beware radon

Monitor humidity

The above may sound as if I don't favor sealing crawl spaces, but in fact I do.

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.

Latest Activity

yangxiaohua posted a blog post

led lighting household decision room style

We seem to be very obsessed with style and…See More
5 hours ago
Jeena Smith commented on Molly Banton's blog post Install a Pellet-Burning Fireplace Insert and Save Money
"Fireplace burning insert must be of very good quality. It should be a combo of lower price and high…"
5 hours ago
Johnny Ritzo posted a discussion

Selecting a Water Heater

I am looking at updating the heating and water heating systems in a rental home I recently…See More
9 hours ago
Eric Kjelshus replied to Patrick Michaelyan's discussion Hot Upper Stories
"When I am asked to fix this home.   I start with a Heat Loss and gain, blower door IR  sq…"
11 hours ago

Edward Foskey just added their location.
(via Member Map)

15 hours ago
Profile IconMartin Easley and Richard Vito joined Home Energy Pros
20 hours ago
Bud Poll replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
"This is a topic I have discussed many times, but unfortunately cost is all too often the deciding…"
yesterday
Sean Lintow Sr replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
"If you can't talk them into replacing with IC rated... Look into Tenmat - those are designed…"
yesterday
Bachi Brunato posted a discussion

Boxing and Insulating Around Non-ICAT Cans

I have a client with 16) 4" halogen recessed light fixtures in the attic.I'd like to cover the cans…See More
yesterday
Dennis Heidner replied to Patrick Michaelyan's discussion Hot Upper Stories
"Could you have them make a simple two line graph of the outside temperature, noting sun/clouds,…"
yesterday
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
"You make some valid points, especially with the base rate charges. Increasing the base rate instead…"
yesterday
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
"Amen, make energy show it's true cost instead of subsidizing it. We have some of the lowest…"
yesterday

© 2013   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service