Hello pros.

Please see the attached pictures.

Any insights on how you would insulate the 2nd story walls of this house? The house is located in the suburbs of Washington D.C.

Thanks!

Patrick

Views: 1206

Reply to This

Replies to This Discussion

Mr. Poll,

I'd take your list for our climate and edit it down to:

4.  As always with ice dams, air sealing and insulation are the first concerns.  Once that is done, then venting can be addressed.

6. Air tightness test and IR can your insulation and air barrier work. If good, drywall.

5. Ignore venting especially in lower slopes.

Have done a few of these in my time. Not easy, but can be done. I have taken 2 rows of shingles off, difficult because you have to get nails from not only the course you want to remove, but also, the row above that. Once the row is removed, I cut a 3 inch square out of the top of the course that is showing and keep that to be replaced. Drill your holes, fill with cellulose, install a tapered wooden plug, cover the plug with roof tar, replace the square you cut out earlier, cover this with a thin coat of roof tar, reinstall your shingle. Labor intensive, but I have had great success with it. Good luck.

Robert

It seems that you describe filing the entire cavity between the vertical interior wall and the steeply pitched lower roof with insulating material - is this correct?  How much insulation is this?  How do you ensure that you have sealed the open joist cavity ends?  In some of these built in recent times, we have seen the plywood interior subfloor extend out to the steeply angled roof so that filling the cavity with insulation does not address the open cavities - and these are the biggest problem with this type of mansard.  Second biggest problem in this particular case is the open party wall at both ends of the house (In this case, just one end because it is an end-row unit).  This open party wall would need some dense-packing.  Both the party wall and the joist cavities are the source of all the moisture that might be in the lower attic - in this DC climate.

You could then drill a 1 inch hole thru the soffit and fill the open end of the floor joists. If the soffit is large enough, drill your normal sized hole and fill it, plug, and patch. You can expect to go thru alot of material as the lower portion flairs out. Anything can be done, only limitations are your comfort levels.

Yikes. It is never as straightforward as one would hope in these "do it right" retrofits. The homeowner is getting itchy about implementing the work, especially because he has been given much misinformation (so it appears) from other "blow it and roll" contractors.

I may have to walk away from this one if he feels confident enough to just settle with more insulation is better than no insulation.

Patrick

Ed,

You put your finger on it: air seal floor cavity! The volume is triangular and the weight and force with dense pack will be borne by the soffit. I love cellulose, but may be best to open it up from below (or if re-roofing pull back the sheathing), do some air sealing and ensure your duct runs are"inside" the house.

Robert,

Very good idea. I have experience with patching roofs and re-roofing so that part will not be a problem.

Much preferred to the going through drywall route, and later having to patch and paint.

Happy holidays!

Patrick

Ok, What has happened since? 

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

Jim Gunshinan posted blog posts
6 hours ago
H.O. Electric posted a photo

about us-team

H.O. Services is your residential Electric-Plumbing-Heating-Cooling Specialist. We are an…
6 hours ago
H.O. Electric added a discussion to the group News & Announcements
Thumbnail

Stay Cool With Easy To Install Ductless AC System!

Stay Cool With Easy To Install Ductless AC System!   Save $300.00 Off A New AC System For A Limited…See More
6 hours ago
Richard Wells commented on Diane Chojnowski's group Facebook Pages
"Three thousand home energy efficiency audits, and nearly a thousand retrofits in four short…"
7 hours ago
Richard Wells joined Diane Chojnowski's group
Thumbnail

Facebook Pages

Does your company or organization have a Facebook Page?This group is for pros who have facebook…See More
7 hours ago
David Baerg replied to Blake Shurtz's discussion Air sealing wood-burning fireplace from the crawlspace below
"Hi Blake, Do you mean around the underside of the hearth?  Are you trying to seal between the…"
8 hours ago
Tom White's video was featured

Rebirth Realty: Restoring Detroit properties for Venture for America Fellows

Its been a long, cold winter, but we've made significant progress in the restoration of 760 Virginia Park. Join Tim Dingman on a walkthrough to see what we've done.
9 hours ago
Kim Tanner added a discussion to the group Multifamily Buildings
Thumbnail

Blower Door Applications Guide

TEC and Camroden Associates have released their big building testing manual, Blower Door…See More
9 hours ago
Profile Iconmichael coleman, Dan Liska and Rob Moreno joined Home Energy Pros
10 hours ago
Christopher Morin's blog post was featured

5 Things New Energy Efficiency HVAC Contractors Need to Know

1. Do not sell on Price! Use 'Simple Payback'The price of High-efficient equipment will undoubtedly…See More
yesterday
Jim Gunshinan's blog post was featured
yesterday
Kim Tanner commented on Diane Chojnowski's group Home Energy Pros on Twitter
"Follow The Energy Conservatory on Twitter! We'll follow…"
yesterday

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service