installing automatic door sweeps
Can anybody tell me if automatic door sweeps can be cut to size? I see some that are 36" long but I need to install one on a 30" basement door. I'm looking for the kind that can be screwed to the inside surface of the door and springs up at an angle when the door is open. There are a couple of brands I see (Frost King & M-D Building Prod.) but I can't really find info on how to install them. Thanks
Views: 182
Replies to This Discussion
-
Permalink Reply by David Meiland on -
Take a look at Pemko. They have good technical info on their site. The 4301 model may be what you want, available as short as 18".
-
Permalink Reply by Robert D York Jr on -
I have used different models throughout the years. Love 'em. They can be cut to any size you want with a hack saw.
-
Permalink Reply by Jose Macho on
-
Must be cut with a hacksaw so that the hinge is not damaged. Biggest problem is placement of the closing cam on the stop trim- using the supplied larger screw may split the stop trim molding so the cam cannot stay on securly so drill a pilot hole or use a smaller diameter screw.
-
Permalink Reply by Kari Sauder on -
thanks to all -- I did find what I was looking for on the Pemko site the second look around and --- I'll remember to install the cam with a pilot hole --- thanks!
-
Permalink Reply by Colin Choney on
-
I would contact the folks at MD Building products and find out what your options are. Their website is mdteam.com
Home Energy Pros
Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
Latest Activity
Edward Foskey just added their location.
Bud Poll replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans"This is a topic I have discussed many times, but unfortunately cost is all too often the deciding…"
Sean Lintow Sr replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans"If you can't talk them into replacing with IC rated...
Look into Tenmat - those are designed…"
Bachi Brunato posted a discussionBoxing and Insulating Around Non-ICAT Cans
I have a client with 16) 4" halogen recessed light fixtures in the attic.I'd like to cover the cans…See More
Dennis Heidner replied to Patrick Michaelyan's discussion Hot Upper Stories"Could you have them make a simple two line graph of the outside temperature, noting sun/clouds,…"
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??"You make some valid points, especially with the base rate charges. Increasing the base rate instead…"
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??"Amen, make energy show it's true cost instead of subsidizing it.
We have some of the lowest…"
Dennis Heidner replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??"The press report really doesn't give enough information to clearly answer why they are…"
Edward Foskey commented on Edward Foskey's blog post Preparing to Update the Heat Pump"Gustavo,
Thanks for the input. I agree with you in that I will be waiting till my system's…"
Gustavo Melo commented on Edward Foskey's blog post Preparing to Update the Heat Pump"Any system that is out of warranty is really a coin toss as to whether it is financially better to…"
Dennis Heidner replied to J.C. Martel's discussion Disasters & sustainable energy"Such as Greensburg…"
© 2013 Created by Lawrence Berkeley National Laboratory.
