http://www.atlassales.com/products/heati...2oach1211/
Go to the section near the bottom for stats on Heat Pump design.
Tags:
Permalink Reply by Curt Kinder on December 16, 2012 at 6:48am How about a better, easier to use link?
I received a "page not found" error" and then a page with hundreds of links, like a table of contents
Permalink Reply by Kevin Wood on December 16, 2012 at 6:55am I can't change that Curt but if you click on the section for Heat Pumps it will have what I count as a good design for Office conditions.
Permalink Reply by Kevin Wood on December 16, 2012 at 6:57am
Permalink Reply by Curt Kinder on December 16, 2012 at 7:05am OK, a portable 1 ton heat pump AC. That's nice, but what's your point?
I imagine that puppy is fairly noisy, and unlikely to be anywhere near as efficient as a fixed system; certainly not a permanent solution.
Why are you posting it here? Is this a backhanded way of advertising your wares? That would seem to abuse the purpose of this site.
Permalink Reply by Kevin Wood on December 16, 2012 at 7:15am No Curt it is to solve a big problem that does occur on the top floors of Commercial buildings being too hot or too cold. I do not endorse or make money of any of these products. Most HVAC systems are combined on a roof and that creates a problem also. I am not here to argue with any individuals and only want to point out solutions.
Permalink Reply by Curt Kinder on December 16, 2012 at 7:36am Fair enough
Permalink Reply by Bob Blanchette on December 20, 2012 at 8:16pm The big issue I see with this unit is where to exhaust the condenser discharge. Most commercial buildings don't have operable windows.
Permalink Reply by dale conner on December 23, 2012 at 7:54pm If the space above the ceiling tile is used as a common return then the condenser will work fine
Permalink Reply by Curt Kinder on December 23, 2012 at 8:11pm Dale,
Do you propose to exhaust portable air conditioners' rejected heat (hot air) into the volume above a typical office drop ceiling?
Permalink Reply by dale conner on December 23, 2012 at 8:34pm only if its being used as a return air cavity (very common)
Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
Bud Poll replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
Sean Lintow Sr replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
Bachi Brunato posted a discussion
Dennis Heidner replied to Patrick Michaelyan's discussion Hot Upper Stories
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
Bob Blanchette replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
Dennis Heidner replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
Edward Foskey commented on Edward Foskey's blog post Preparing to Update the Heat Pump
Gustavo Melo commented on Edward Foskey's blog post Preparing to Update the Heat Pump
Dennis Heidner replied to J.C. Martel's discussion Disasters & sustainable energy
Tom Delconte commented on Edward Foskey's blog post Preparing to Update the Heat Pump
Jim Gunshinan commented on Jim Gunshinan's blog post The Universe Is Made of Stories© 2013 Created by Lawrence Berkeley National Laboratory.