http://www.atlassales.com/products/heati...2oach1211/

Go to the section near the bottom for stats on Heat Pump design.

Views: 309

Reply to This

Replies to This Discussion

How about a better, easier to use link?

I received a "page not found" error" and then a page with hundreds of links, like a table of contents

I can't change that Curt but if you click on the section for Heat Pumps it will have what I count as a good design for Office conditions.

OK, a  portable 1 ton heat pump AC. That's nice, but what's your point?

I imagine that puppy is fairly noisy, and unlikely to be anywhere near as efficient as a fixed system; certainly not a permanent solution.

Why are you posting it here? Is this a backhanded way of advertising your wares? That would seem to abuse the purpose of this site.

No Curt it is to solve a big problem that does occur on the top floors of Commercial buildings being too hot or too cold. I do not endorse or make money of any of these products. Most HVAC systems are combined on a roof and that creates a problem also. I am not here to argue with any individuals and only want to point out solutions.

Fair enough

The big issue I see with this unit is where to exhaust the condenser discharge. Most commercial buildings don't have operable windows.

If the space above the ceiling tile is used as a common return then the condenser will work fine

Dale,

Do you propose to exhaust portable air conditioners' rejected heat (hot air) into the volume above a typical office drop ceiling?

only if its being used as a return air cavity (very common)

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

R Higgins replied to William Fisher's discussion Can tankless water heaters provide hot water even when the groundwater is fairly cold?
"I have that problem, 45 to 50 degree ground water, in summer, not that we have much of a…"
5 hours ago
R Higgins replied to Larry Schaffert's discussion How to correctly insulate exterior wall in a 1900 house?
"I'd suggest trying to replicate the existing conditions as much as possible in your rebuild,…"
5 hours ago
Bryan Pringle replied to Bryan Pringle's discussion Dense packed cellulose in basement?
"I am getting a lot of "bad idea" push back on this.  I fully understand that…"
17 hours ago
Greg Mitchell commented on Larry Ralph Jr's blog post Top 7 Worst Crawl Space Repairs
"Spray Foam should be used in crawlspaces.   To learn about closed cell foam in crawlspaces…"
17 hours ago
Jerry Lawrence posted events
yesterday
Morgan M Audetat replied to Bryan Pringle's discussion Dense packed cellulose in basement?
"Right you are. You have to ask: what will the cellulose contribute.  Here in Minneapolis we…"
yesterday
Morgan M Audetat replied to Tony Hicks's discussion Slab-on-grade Insulation
"All slabs float. We have been installing radiant floors on various slab constructions since the…"
yesterday
Tony Hicks replied to Tony Hicks's discussion Slab-on-grade Insulation
"2" XPS foam. I'd love an R-20. Having foam thick enough to get an R-20 would be…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service