Funky Duct Test

Replies to This Discussion

Permalink Reply by David Meiland on April 23, 2012 at 9:56pm

Hard to see how there could be +135 in one supply duct without at least some positive reading everywhere else. Maybe someone accidentally (?) tied a bath fan into that duct.......

• ▶ Reply

Permalink Reply by Bill Bennett on April 24, 2012 at 6:55am

No power to the house at time of testing.

• ▶ Reply

Permalink Reply by Glen Gallo on April 24, 2012 at 6:39am

someone stepping on the hose?

• ▶ Reply

Permalink Reply by Bill Bennett on April 24, 2012 at 6:55am

No.

• ▶ Reply

Permalink Reply by Bud Poll on April 24, 2012 at 6:52am

I would tend to agree with Glen, as a blocked tube will clock up rather fast.  If there is still a pin hole I suspect the pressure would stabilize at some point, although I'm not going to test it.  It could have been a kink somewhere that unfolded when you moved the hoses.  If it was a positive pressure the block was on the input.  If negative it would have been on the reference, DG700 at least.

Bud

• ▶ Reply

Permalink Reply by Bill Bennett on April 24, 2012 at 7:09am

I just submitted this to the Energy Conservatory.  If I get something useful back from them, I'll post it here.

• ▶ Reply

Permalink Reply by Bill Bennett on April 26, 2012 at 7:04am

As promised, I asked the folks at The Energy Conservatory about my funky duct test results.  Paul Morin, a Technical Sales Specialist suggested that such a situation could occur if the hose is stopped up or perhaps was up against insulation in the supply boot.  He went on to say; "You can simulate a pressure this high by putting your finger over an open tap on the DG-700 gauge.  It is harder to reproduce a pressure that high with a long length of hose attached, but you would see pressures that high if some debris is plugging the hose.  You also will see pressures that high if the hose is pinched, stepped on or if there is water in the hose."  

I believe that the end of the metal probe must have been up against the boot insulation, probably when I taped the hose  to secure it. The resulting restriction of air caused the errant reading.

Thanks to everyone who offered a suggestion.  

• ▶ Reply

Permalink Reply by Matt Marshall on May 18, 2012 at 4:09am

Something else to look out for.  If you use the metal probe to punch through the plastic tape you can actually punch a hole in the plastic tape which will cover the end of the probe.  I've had this happen to me and it caused some temporary confusion.

• ▶ Reply