Views: 600

Replies to This Discussion

Oh, that gave me a serious belly laugh at work. Jeez.

Sorry for the lack of focus -- new camera -- It's sitting on pavers on the right side but not the left.  It doesn't look too out of plumb in this shot but it was maybe 1" from top to floor.  The installer gets one brownie point for putting on a pipe-down but....this is soo bad.

Notice the duct tape around to protect the WH's finish from the strap which --- would have been better used around the dryer vent hose at least to seal it.

It should probably have had two straps for seismic hold down... and gas line looks like an opportunity for a small child to stand on and bounce.   That is also questionable... some states require a flexible connection between the appliance and the gas line - for seismic reasons.   It looks like the total length of the unsupported gas pipe might exceed four feet easily... and that should have been a code violation.   (can we say KABOOM...)

I really can't tell from the first picture how the venting is hooked up... was the plastic bag part of their vent system?  If so they may have suspected they had some kind of back draft problem... and tried to cure that with the bag?  I can't imagine a mechanical permit was pulled to install the heater... a licensed person would not have done that...  it had to be a DIY job.

This is also a powered vent hot water heater... nice electrical installation....   :-(   at least there would be a source of ignition for the broken gas line...  

One last comment -- click on pictures... the first picture changes when you click on it so you can actually see the blocking under one side.

Most gas hot water heaters are also supposed to be place about a foot above the floor -- such that fumes from a flammable source remain below the level of the pilot... this installation also lacks that....

As far as seismic activity -- this is PA not CA so no WH's have hold downs here...I don't like the gas line either but I think the reason why the WH is leaning is b/c they wanted to hook up to the existing line.

 I agree with seeing an opportunity for children's play.  I'll check the code on that.

 The plastic bag had the operating manual in it -- it's not part of the installation ( incidentally, the installation manual was no where to be found) -- had to look it up on line.  The new foil slinky hose connects to the existing 3" PVC running between the floor joists and out to the sidewall about 10' away.

 Yeah -- you should have to have a master plumber change out a WH in this municipality but it kinda looks like someone was flying under the radar on this one.  I think the WH power cord is plugged into the furnace outlet -- I forget just what was going on there...

Thx for the comment about the pictures -- I loaded 2 the first time and then couldn't find the second one so I loaded another one -- I'm still getting the hang of this software, I guess.

There's not room to put it up any higher than it is really.  But I'll mention no flammables storage to the homeowners.

I'm pretty sure code would also require separate outlet for the WH... it should not be piggy backed off the breaker for the furnace...even though it is a low current device.   Similar rules (some states) are for separate outlets for washer & dryers (even gas dryers).

I'd still check current codes about seismic ties for WH...the northeast and midwest has had earthquakes... and other disasters... so I suspect even the PA state buiding codes may require some kind of simple tie to the structure.

Since there is power going to the vent fan for the furnace... you should also check to see if there is a requirement for bonding the water pipes to the earth ground at the electric panel...

It's all better now.  It's sitting plumb with glued PVC venting and the gas line is shorter, closer to the wall, and strapped to the floor joist above.  And I checked the gas line from the basement wall where the meter is all the way to the furnace and WH -- no leaks.

Cool... a success story... without the fireworks...

Amen! -- you can say that again.

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

Tom Conlon posted a discussion

Whole House Fans - Love 'Em or Not?

I just searched this forum for "Whole House Fan", but I didn't find much about them (except …See More
5 minutes ago
Richard Beyer replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"Don, Thank you for the praise! I only wish that some of these profiteers could answer my questions…"
2 hours ago
Richard Beyer replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"Todd, This report (attached link) below on poor people living in subsidized housing show's…"
2 hours ago
Mike Kandel added 4 discussions to the group Building Performance Institute (BPI)
4 hours ago
Mike Kandel posted discussions
4 hours ago
Nate Adams commented on Jim Gunshinan's blog post My Energy Upgrade California—The Numbers Are In
"Jim, Glad to help! OK, a touch of soap box. So long as we don't tell people EE is free and…"
5 hours ago
Kurt Shafer commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Bob, Good idea. I see that you are a window energy reduction expert. You might consider adding…"
5 hours ago
Robert (Bob) Bacon commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Kurt, I would explain what energy/efficiency problem this device solves and explain the science the…"
6 hours ago
Ben Jacobs replied to Mike Kandel's discussion Our Homes Suck – And That's Why Our Kids Have Sinus Problems
"I agree that in many homes the indoor air sucks.  However, a lot of this problem is caused…"
7 hours ago
Kurt Shafer commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Tom, thank you for your odd reference to a leaky duck. It is a bit off topic since I was not asking…"
8 hours ago
Tom Delconte commented on Kurt Shafer's blog post What is your opinion about members promoting products here?
"Shameless self promotion here sucks like a leaky duck!"
10 hours ago
Profile IconJohn A Deuth, Lisa M. Harr and Ramon Aguirre joined Home Energy Pros
10 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service