http://greendreamgroup.libsyn.com/this-house-sucks-but-not-very-har...

Check out this interview with brilliant scientist Brett Singer (seriously, he's a genius) from Lawrence Berkeley National Laboratory on our misconception about worst case CAZ Depressurization testing.

Tags: bpi, brett, case, caz, podcast, singer, testing, worst

Views: 1094

Reply to This

Replies to This Discussion

Even when gas stoves DO have exhaust fans they capture a small % of the combustion products. Note when a boiling pot is on the outside burners, most of the steam bypasses the exhaust hood. Inside burners get more of the exhaust. Even with 250 CFM the face velocity is way to small to capture all that much. 

solution - stoves need to be enclosed on three sides. NO one makes a stove like this but they should. This will more than double the face velocity an improve capture. Stainless side panels would do it and also eliminate splattering on adjacent counter tops. 

Good point. Now, assuming all of us here agreed, whom do you think we will win over first:
Appliance manufacturers or my wife?

Decades of experience in the Culinary realm give me a slightly different perspective.  It is the capture area of the hood that is of significance.  Installing sides will never go over, but if the hood were required to extend some predetermined amount beyond the cook surface and coupled with an appropriately sized fan motor, I believe the dynamics would fall into an acceptable range.

Hi Jim, just to add to your example from another perspective, a capture hood should also be more than a flat surface with an exhaust hole in the middle and skirting around it.  Take for example the fireplace industry that has to produce a draft without the fan.  By tapering the combustion chamber up to the flue there is a gradual acceleration of the air flow and less turbulence.  I suspect a little more air flow engineering as opposed to aesthetics would add to the effectiveness of hood design.

We must remember that the fan is not pulling the air from above the cooking surface up into the exhaust, just creating a low pressure zone in the vent so that the surrounding higher pressure can push all of that air into the little hole (just like a fireplace).

Bud

Actually engineering the flow would make sense. Maybe they need to attach the hood to the pot lid; now there is totally new paradigm.  Air jets blowing upwards around the edge of the cooktop would help also. After all that, there is still a need for some reasonable velocity to contain the products of combustion on the gas stove, the steam and smoke.  Apart from adding more flow, we haven't progressed at all in kitchen exhaust. 

Lizzy bought one of those NuWave induction stoves.  I've always hated electric and loved gas.  

I guess I have bias against induction that I wasn't aware of because even though there are all types of reviews raving about induction, experiencing it in person left me shocked.  (And I try to be open to having my schemas disrupted!)

In my mind cooking with gas is done.  If you haven't tried induction cooking, try it.  If you have tried it, and see any reasonable argument FOR gas, I'd be interested to hear it. 

Very interesting. Brett did a good job of explaining complicated subject and boiling down (pun intended)  points.

my favorite was "If you are going to do test that is going predict an unlikely event will happen then you need to do allot of monitoring to see if this event will happen"

I do not think we will see any changes anytime soon for CAZ but the podcast was a good refresher on the dangers of the gas stove top that I can take forward. I am glad that cfm in still equals cfm out

It also brings forward to me the need for mechanical ventilation. Many problems can be eliminated through dilution.  A good balanced ventilation system designed for the applicable climate is still one of the best things we can recommend for any home.

Good stuff

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

tedkidd commented on Scott Mellberg's blog post Lessons from Energy Efficiency Advisors: Getting Homeowners Onboard with Home Performance
"Absolutely agree Ben, "How much do I use, how much do others use, and what is my reasonable…"
33 minutes ago
Profile IconTauran Ivall, Alex Burnham and Annika Brink joined Home Energy Pros
1 hour ago
David Eakin replied to Jamie Kaye's discussion Flickering LED lights
"I also thought that, but I tried to put a CFL in the A-19 outside fixture at my…"
1 hour ago
Ben Jacobs commented on Scott Mellberg's blog post Lessons from Energy Efficiency Advisors: Getting Homeowners Onboard with Home Performance
" I believe a major problem of government, of energy utilities, and home energy efficiency…"
2 hours ago
Jill Lindman posted an event

EEBA Houses That Work Education & Training at Johnson County Administration Building

August 22, 2014 from 8:30am to 4:30pm
About the SessionsIntro to Houses That Work: In this session participants learn how the many…See More
3 hours ago
Glen Gallo replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Title 24 requires whole house fans in zones 8-14 in the prescriptive path only. With many…"
4 hours ago
Jenn Saunders replied to Jenn Saunders's discussion iEnergyApp: Quickly generate professional reports for homeowners and get more contracts!
"Hey Tom, You are most welcome.  iEnergyApp is not free, but it is reasonable and pays for…"
4 hours ago
Jenn Saunders posted a photo

Automatically Generate Clean Simple Reports for Homeowners

Stop spending hours cropping and resizing images, formatting and reformatting a Word document to…
4 hours ago
Eric Sperline added a discussion to the group Energy Auditing Equipment for Sale, Trade or to Purchase
Thumbnail

Beware ebay seller "supermomofps"

I bought a blower door system on Ebay from "supermomofps"  The item was never sent and…See More
5 hours ago
Larry Nissman replied to John Shillito's discussion Fixing a water heater?
"I have to agree with Kurt. 2000 ppm is exceedingly high. I have tested hundreds of hot water heater…"
5 hours ago
Tom White's video was featured

Passive House Revolution - Film Trailer

Looking for energy-efficiency in buildings? There's no need to wait for new technology - Passive House buildings use 80-90% less heating and cooling energy.
5 hours ago
Diane Chojnowski joined Hal Skinner's group
Thumbnail

Radiant Control Coatings

A group where people who work with radiant barrier coatings can let others know all of their uses.See More
5 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service