Ballasted roofs. How prevalent and how effective at energy efficiency are they?

I dont see a whole lot of these in my area.  Until recently I did not realize that they can be designed to meet 'Cool Roof'. specifications.

 

How many of these do you see in your area?  These are extremely heavy roofs with that much rock.

Views: 208

Reply to This

Replies to This Discussion

Found at the link Hal provided:  "A typical ballasted roof system consists of 10 pounds per square foot (49 kg/m2) of river-rock ballast over an EPDM membrane, rigid insulation and a metal roof deck."
I haven't seen one in years, generally we busy ripping them up & replacing them due to leaks & deterioration - personally I rather see a layer of insulation & a coating, and so would the owners when it comes time to repair or replace it

I agree with you.  I can't remember how long it has been since I have seen one even getting replaced.

 

Here we have the DOE setting standards for ballasted roofs so they can be considered a 'Cool Roof' also along with all the other types of roofs..  This would surely be considered a good thing if it is more energy efficient than a ballasted roof without the coating.  However, ( and speaking only for our roof coating)  there is absolutely NO WAY we would ever give a warranty for this specific application.  Rocks on top of our coating would not phase it's performance in the cold months but would definitrly drop its effectiveness in the hot months.

Spoke to the inventor of our coating yesterday.  He has not seen a ballasted roof in at least 20-years.

Anyone have any ideas where they are still used?????

Apperently ballasted roofs are still used in the UK and other parts of Europe as well as a few areas in the US.  News to me!

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Mariusz Chorazy posted a blog post

Here are a few tips to keep your air conditioning bill low

TAKE GOOD CARE OF YOUR AIR CONDITIONER – Like any major appliance, your AC requires regular…See More
16 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Morgan, I got this below from the Knight installation manual. I note a few things, -These…"
19 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
yesterday
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
yesterday
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
yesterday
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
yesterday
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
yesterday
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service