I have been able to reduce the leakage rate of a challenging house built in the 1920s.

Still, the homeowners are adamant about wanting to address a couple of tough spots, and I need some help. The two spots are the mail slot in the front storm door and the attic fan.

The mail slot:

The attic fan:

So, the attic fan is the focus for now. Notice the door hardware on each side of the wood panel walls. The HOs still want to be able to access the closets with whatever solution is pursued. They do not want to remove the fan.

Originally, I was going to fabricate a panel of rigid foam insulation that would extend from the floor to the ceiling. I was going to make sure the rigid foam panel could be easily removed and replaced. 

Any thoughts on how to seal the attic fan and\or mail slot in the storm door?

Thanks in advance!

Patrick

Views: 3334

Reply to This

Replies to This Discussion

It appears the mail slot in the wrought iron goes through the solid wood door? Can you post the interior portion of the mail slot?

Nothing constructive to add, but the idea of air sealing a home with an attic fan that large scares me.  Is it serving as a whole house fan or is there an intake area to supply air flow from just the attic?

Bud

Hello Bud.
It's something I would normally be concerned with as well, but this house is very leaky. 5,500 CFM50, with a BAS near 3,000. The majority of the leakage is concentrated in the basement and the attic. I concentrated all my efforts thus far on the basement (where there was also pest issues).
So, does a leaky house with a whole-house fan pose a problem with regard to safety? 
My sense is that all such questions can be eliminated with sealed combustion equipment, but, then again, what about gas ranges, ovens, etc?

First, the mail slot.  If the mail can drop into a pocket that has another sealed access from the inside, at least it would be air tight. 

The good news is that old homes can rarely get too tight, however, what size is that fan.  A BAS of 3000 would be a natural around 150cfm, if my thinking is correct.  And a fan that size could be 3 times that volume, driving the entire house negative.

I'm in north country and often hear the excuse that a whole house fan and a furnace don't need to run at the same time.  Well, they may not need to, but it could inadvertently happen.  A fan left on from a hot day and the stat picks up a call for heat and suddenly you have a house full of fumes or worse.  I always suggest an electrical interlock where the furnace or stat is locked out when the fan is running.  Applies to range hoods as well. 

You didn't mention where that fan is pulling its air from, the house, a window, or attic venting.

Is the hot water gas or oil?

Bud

The electrical interlock you speak of sounds promising (given the number of houses I have encountered with whole-house fans).

As for the size (capacity) of the fan I don't have that info handy.

The fan is pulling its air from leaks in the attic to the outside, as well as leaks between the attic and the rest of the house. As with most folks, they only run it in the summer (with a whole lot of windows open). 

The hot water is gas.

You raise an interesting idea thought about the pocket with sealed access. I need to think that one through a little.

Would it be possible to build a pair of bifold (closet) doors in front of the fan? I would install an interlock there as well so the fan can only run when the doors are open. Obviously, you will need to have a way to lock them open. This may not completely reduce leakage through the fan, but it should reduce it substantially. 

Do they have gas cooking appliances? 

They have a gas range\oven.

The bifold doors complete with an interlock sounds very promising...if I can reduce the leakage substantially then I'm happy, as I sure the HOs will be as well.

Thank you Bruce.

hey Patrick ...

I think the 1st thing I would do is to completely/ temporarily seal both the mail slot & whole house fan and do a blower door ... then do without sealing to see the implication ... if it is not all that significant, why worry ?

That is also a route I thought about taking Paul. It is my sense that the attic fan is worth sealing up, but it is the HOs prerogative that the mail slot be sealed (they say it is drafty in the foyer and front hallway during the winter).

I will post the results of BD testing for the attic fan and mail slot after I get the chance to put together a temporary seal for the fan (and maybe the mail slot).

Regarding the storm door-is it an older one? It appears to be steel with single pane glass. Is that so? Could the HO's impressions be as much about the door being a thermal bridge?

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.

Latest Activity

tedkidd commented on Scott Mellberg's blog post Lessons from Energy Efficiency Advisors: Getting Homeowners Onboard with Home Performance
"Absolutely agree Ben, "How much do I use, how much do others use, and what is my reasonable…"
35 minutes ago
Profile IconTauran Ivall, Alex Burnham and Annika Brink joined Home Energy Pros
1 hour ago
David Eakin replied to Jamie Kaye's discussion Flickering LED lights
"I also thought that, but I tried to put a CFL in the A-19 outside fixture at my…"
1 hour ago
Ben Jacobs commented on Scott Mellberg's blog post Lessons from Energy Efficiency Advisors: Getting Homeowners Onboard with Home Performance
" I believe a major problem of government, of energy utilities, and home energy efficiency…"
2 hours ago
Jill Lindman posted an event

EEBA Houses That Work Education & Training at Johnson County Administration Building

August 22, 2014 from 8:30am to 4:30pm
About the SessionsIntro to Houses That Work: In this session participants learn how the many…See More
3 hours ago
Glen Gallo replied to Tom Conlon's discussion Whole House Fans - Love 'Em or Not?
"Title 24 requires whole house fans in zones 8-14 in the prescriptive path only. With many…"
4 hours ago
Jenn Saunders replied to Jenn Saunders's discussion iEnergyApp: Quickly generate professional reports for homeowners and get more contracts!
"Hey Tom, You are most welcome.  iEnergyApp is not free, but it is reasonable and pays for…"
4 hours ago
Jenn Saunders posted a photo

Automatically Generate Clean Simple Reports for Homeowners

Stop spending hours cropping and resizing images, formatting and reformatting a Word document to…
4 hours ago
Eric Sperline added a discussion to the group Energy Auditing Equipment for Sale, Trade or to Purchase
Thumbnail

Beware ebay seller "supermomofps"

I bought a blower door system on Ebay from "supermomofps"  The item was never sent and…See More
5 hours ago
Larry Nissman replied to John Shillito's discussion Fixing a water heater?
"I have to agree with Kurt. 2000 ppm is exceedingly high. I have tested hundreds of hot water heater…"
5 hours ago
Tom White's video was featured

Passive House Revolution - Film Trailer

Looking for energy-efficiency in buildings? There's no need to wait for new technology - Passive House buildings use 80-90% less heating and cooling energy.
5 hours ago
Diane Chojnowski joined Hal Skinner's group
Thumbnail

Radiant Control Coatings

A group where people who work with radiant barrier coatings can let others know all of their uses.See More
5 hours ago

© 2014   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service