Selling with Rebates: The Simple Payback
The easiest way to show a homeowner how their investment in high-efficient equipment will help…See More
Air Sealing Woes
I have been able to reduce the leakage rate of a challenging house built in the 1920s.
Still, the homeowners are adamant about wanting to address a couple of tough spots, and I need some help. The two spots are the mail slot in the front storm door and the attic fan.
The mail slot:
The attic fan:
So, the attic fan is the focus for now. Notice the door hardware on each side of the wood panel walls. The HOs still want to be able to access the closets with whatever solution is pursued. They do not want to remove the fan.
Originally, I was going to fabricate a panel of rigid foam insulation that would extend from the floor to the ceiling. I was going to make sure the rigid foam panel could be easily removed and replaced.
Any thoughts on how to seal the attic fan and\or mail slot in the storm door?
Thanks in advance!
Patrick
Views: 2100
Replies to This Discussion
-
Permalink Reply by tedkidd on -
Does the house have air conditioning?
What type of furnace - what draft type?
Does the water heater have a spill switch or some type of safety in the event of backdrafting?
A guy in Syracuse was killed by a whole house fan a few years ago. If I recall correctly, hot day turned to cool evening and his furnace kicked on. He forgot to turn the fan off, it backdrafted his furnace and he died of CO poisoning.
People seem to think these things save college tuition payments. It's very likely the wintertime loss through that huge high in stack hole costs WAY more that the few sheckles it saves on A/C - if it even saves (definitely can cause higher latent load due to operator ignorance).
-
Permalink Reply by Patrick Michaelyan on -
Central AC.
A high-efficiency (sealed combustion) gas furnace, and an natural draft gas boiler.
Quite frankly the DHW unit should be replaced asap. There is not a single safety feature on the unit to speak of.
Damn shame about the guy in Syracuse. That story and all the input thus far really drives home the point of combustion safety for me.
At this point my goal will be to convince the HOs to replace the existing DHW unit with an indirect tank, and hope they will go for a high-efficiency gas boiler. Next I will try to convince them to replace the existing FG batt insulation in the rafters with either 3-4" closed cell foam, or a flash and batt approach, or a rigid and cellulose cavity fill approach. Then we can discuss an upgrade to a smaller, more efficient fan.
Any issues y'all have with this thinking on my part?
-
Permalink Reply by tedkidd on
-
If they have AC, what is the point of the fan? Do they think it saves them energy?! Do they realize how incredibly efficient properly designed AC is these days? Ask how much they "think" the attic fan saves them!
How silly does it sound to take a towel out of the dryer only to throw it in the pool?
People with attic fans remove ton's of latent all day, then throw open windows and suck it back in at night. Furnishings absorb the moisture and become uncomfortable. Houses become clammy, and moldy. Dehumidifiers in basements run continuously attempting to dehumidify the great outdoors. It's completely absurd.
Fix the house, teach them to use the AC, and let them see the fan was costing them energy, comfort, and IAQ. Attic fans have absolutely no place in a home with AC, they work at cross purposes.
-
Permalink Reply by Patrick Michaelyan on
-
Thanks Ted.
I have begun the process of convincing the HOs of completely re-thinking the systems currently in operation for their house.
We'll see where this goes.
Patrick
-
Permalink Reply by Dale@EnergyWright on -
Show the HO the total house and CAZ depressurization with all exhaust fans running and just the whole house fan running. You may be back-drafting the DHW now. Use the blower door to pressurize the house back up to zero Pascals. Cruise control works good for this application. The CFM through the fan is very close to the total CFM exhaust of all the fans, or the whole house fan if that is all that is running.
Once you know the total exhaust fan CFM, you can calculate what the house depressurization will be after air-sealing to the BAS. Use dP = 50*((CFMfan/CFM50)^(1.54)) to calculate the predicted depressurization. As an example, if your exhaust fans total 400 CFM, your house depressurization will go from -1 Pa. to -2.3 Pa. when you tighten the house to 3000 CFM50 from 5000.
A Heat Pump Water Heater (HPWH) may be the way to go to eliminate the risk of backdrafting a water heater. HPWHs are worth checking out.
-
Permalink Reply by Patrick Michaelyan on
-
Thanks Dale, great advice.
Also, in regard to the HPWHs, I have pushed a few before but have yet to have any bites. I will def continue the push for HPWHs.
Patrick
- ‹ Previous
- 1
- 2
- 3
- Next ›
Home Energy Pros
Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.
Latest Activity
Mike Rogers's blog post was featuredHOMES Act introduced with Bi-Partisan Sponsorship
We don't see a lot of bi-partisan bills in Congress these days. Here's one focusing on home…See More
Mike Rogers posted a blog postHOMES Act introduced with Bi-Partisan Sponsorship
We don't see a lot of bi-partisan bills in Congress these days. Here's one focusing on home…See More
David Eggleton replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??"That varies, as policies are different from state to state."
Orvil D Boyer replied to David Starrett's discussion I am looking for a good IR camera in the group Energy Auditing Equipment for Sale, Trade or to Purchase"I have a Fluke TIR 32. Used aproximately 10 times 1.5 yrs old. This is the first…"
Orvil D Boyer joined allen p tanner's group
Energy Auditing Equipment for Sale, Trade or to Purchase
Discuss the pros and cons of the equipment you are interested in prior to purchase. Post equipment…See More
George Kopf posted a discussionMisting Aeroseal in Pressurized Home = Amazing Air Sealing Innovation
As a training program manager for a non-profit, I am often too busy managing my program to catch…See More
Dennis Heidner replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??"Ben, the German highway system concept actually started BEFORE Nazi Germany during the…"
Stan Kuhn replied to Patrick Michaelyan's discussion Hot Upper Stories"You note overheating on the south side (naturally.) Assuming the typical roof overhang of…"
Patrick Michaelyan replied to Patrick Michaelyan's discussion Hot Upper Stories"Thanks a lot Ed. And thanks to all who have added their two cents.
I think I know where to take…"
Ed Minch replied to Patrick Michaelyan's discussion Hot Upper Stories"We have successfully treated this same problem in perhaps 1000 of this same house in the…"
© 2013 Created by Lawrence Berkeley National Laboratory.
