George J. Nesbitt's Discussions (27)

Discussions Replied To (26) Replies Latest Activity

"Historically we have done an air barrier on the inside, lot's of intersections, peni…"

George J. Nesbitt replied May 15, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"While code may not require adding ventilation to an existing kitchen, I would never…"

George J. Nesbitt replied May 15, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"Can you create an air barrier (5/8" drywall or 1/2" ply) at the ceiling level? elimi…"

George J. Nesbitt replied May 4, 2014 to Square Recessed Lights

10 Jan 2
Reply by Dennis Heidner

"1) not important; air leakage can introduce pollutants to the building (dust, moistu…"

George J. Nesbitt replied Apr 30, 2014 to On the Question of Airtightness and Energy Performance

28 Jun 20, 2014
Reply by Brennan Less

"Equipment is rated for it's configuration (ducted or ductless). So you can compare e…"

George J. Nesbitt replied Apr 30, 2014 to Air Source Heat pump or mini-split efficiency

1 Apr 30, 2014
Reply by George J. Nesbitt

"Sorry, I meant to say NOT recognized."

George J. Nesbitt replied Apr 30, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"AAV's are NOT recognized in the state plumbing code, although they are in the IRC (i…"

George J. Nesbitt replied Apr 30, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"CA modifies the National / International codes, and does not allow some things, but…"

George J. Nesbitt replied Apr 30, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"I've done a recirculating hood with an ERV in Berkeley, the city did not notice."

George J. Nesbitt replied Apr 30, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

"The owners (like Alice) have had varying degrees of involvement, mainly on the plann…"

George J. Nesbitt replied Apr 27, 2014 to Affordability & Deep Energy Upgrade/Passive House Retrofit in Berkeley, California.

85 May 22, 2014
Reply by Kaushal Bharath Raju

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
5 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
5 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
8 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
9 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
10 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
11 hours ago
Lars olsen posted a blog post
19 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service