Chris Peters's Discussions (8)

Discussions Replied To (8) Replies Latest Activity

"I will second that motion. Who can do it? Consumer Reports?"

Chris Peters replied Apr 4, 2011 to Energy Modeling Software - what works??

48 Feb 23, 2012
Reply by Jim Baerg

"There isn't one that I know of. I built one for personal use. It has initially the B…"

Chris Peters replied Mar 31, 2011 to Let's hear your feedback on Home Energy Pros!

28 Mar 12, 2012
Reply by Evan Mills

"Eric, I am BA, Envelope and Heating BPI Certified. I have quite a bit of experience…"

Chris Peters replied Mar 14, 2011 to Drilling through a flue pipe of a power-vented combustion appliance

17 Mar 14, 2011
Reply by David Meiland

"You're very welcome."

Chris Peters replied Mar 11, 2011 to Where to install the vapor barrier for a finished basement?

7 Jan 25
Reply by Ken Watts

"I'm referencing Joe Lstiburk's "Cold Climates" You should not install poly on the wa…"

Chris Peters replied Mar 11, 2011 to Where to install the vapor barrier for a finished basement?

7 Jan 25
Reply by Ken Watts

"I guess I can't see why one cannot go outside and test at the vent terminal. Then th…"

Chris Peters replied Mar 11, 2011 to Drilling through a flue pipe of a power-vented combustion appliance

17 Mar 14, 2011
Reply by David Meiland

"I have to disagree with you on using those plugs. Cat IV PVC flues are pressurized a…"

Chris Peters replied Mar 10, 2011 to Drilling through a flue pipe of a power-vented combustion appliance

17 Mar 14, 2011
Reply by David Meiland

"Blaine, you beat me to it. There is a huge difference between a positive pressure Ca…"

Chris Peters replied Mar 4, 2011 to Drilling through a flue pipe of a power-vented combustion appliance

17 Mar 14, 2011
Reply by David Meiland

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy, under the American Recovery and Reinvestment Act) and brought to you in partnership with Home Energy magazine.

Latest Activity

Stan Kuhn replied to Patrick Michaelyan's discussion Hot Upper Stories
"You note overheating on the south side (naturally.)  Assuming the typical roof overhang of…"
1 hour ago
Patrick Michaelyan replied to Patrick Michaelyan's discussion Hot Upper Stories
"Thanks a lot Ed. And thanks to all who have added their two cents. I think I know where to take…"
2 hours ago
Ed Minch replied to Patrick Michaelyan's discussion Hot Upper Stories
"We have successfully treated this same problem in perhaps 1000 of this same house in the…"
3 hours ago
Craig Savage commented on Craig Savage's video
Thumbnail

What is a Heat Pump Water Heater

"Hello Tom We are working with A.O. Smith, GE and Stiebel Eltron on a Building America task to…"
4 hours ago
Tom Delconte commented on Craig Savage's video
Thumbnail

What is a Heat Pump Water Heater

"Craig: I was serious, since my propane price jumped from .98 to 1.85! according to everyone the GE…"
5 hours ago
Ben Jacobs replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
"I think that government support for good ideas results in major benefits over the long haul. Please…"
6 hours ago
Craig Savage commented on Craig Savage's video
Thumbnail

What is a Heat Pump Water Heater

"Hello Tom Not sure if you are being sarcastic, but a serious answer would be that GE is selling…"
8 hours ago
Tom Delconte commented on Craig Savage's video
Thumbnail

What is a Heat Pump Water Heater

"Craig: do you have a diagram of one that will run longer than one year? They don't really seem…"
9 hours ago
Cory Chovanec replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
"All good points brought up. My advice is not to leave the lights. When you said halogen I think…"
10 hours ago
Jon Haehnel replied to Jose Macho's discussion Why Are Energy-Saving Home Inprovements Down??
"The first 2 answers by Tom and Sean jive with my thinking and experience. Thank you Don for…"
11 hours ago
Tom Smith replied to Patrick Michaelyan's discussion Hot Upper Stories
"The most bang for your buck will come from airsealing the attic plane and sealing the…"
11 hours ago
John Rising replied to Bachi Brunato's discussion Boxing and Insulating Around Non-ICAT Cans
"Hi Bachi, We have done many projects where we have installed boxes around recessed lights to…"
12 hours ago

© 2013   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service