Paul Lasicki's Discussions (44)

Discussions Replied To (17) Replies Latest Activity

"Thanks, that worked."

Paul Lasicki replied Aug 8, 2012 to App for Ashrae 62.2

4 Aug 9, 2012
Reply by Isaac Savage

"Great, thank you. Paul"

Paul Lasicki replied Aug 7, 2012 to Cost of foam installation

4 Aug 7, 2012
Reply by Paul Lasicki

"Not much to go on, but, thanks any whey."

Paul Lasicki replied Aug 5, 2012 to Cost of foam installation

4 Aug 7, 2012
Reply by Paul Lasicki

"OK, thanks, I was leaning in that direction."

Paul Lasicki replied Apr 23, 2012 to New BPI certifications re-visited

7 Apr 23, 2012
Reply by David Eggleton

"Good idea, thanks"

Paul Lasicki replied Apr 23, 2012 to New BPI certifications re-visited

7 Apr 23, 2012
Reply by David Eggleton

"Hey Sean, I'm with the Home Performance program here in NY and was required to have…"

Paul Lasicki replied Apr 23, 2012 to New BPI certifications re-visited

7 Apr 23, 2012
Reply by David Eggleton

"I find it's usually too costly for the client and too labor intensive. Most people g…"

Paul Lasicki replied Apr 20, 2012 to Building Airflow Standards and the Average Contractor

17 Apr 30, 2012
Reply by Patrick Michaelyan

"It has been proven that foaming interior and exterior top plates has significantly r…"

Paul Lasicki replied Feb 29, 2012 to Soffit Overhang Spray Foam

11 Feb 29, 2012
Reply by tedkidd

"Be careful with an oil to propane conversion. You may actually end up paying more wi…"

Paul Lasicki replied Feb 23, 2012 to What is the best propane direct vent wall furnace available?

5 Feb 23, 2012
Reply by Paul Lasicki

"I'm on the same page with you. Presently I also spot seal and insulate w/ faced f.g.…"

Paul Lasicki replied Feb 11, 2012 to Insulating floors above basements with fuel-fired boilers\furnaces.

23 Nov 3, 2012
Reply by Patrick Michaelyan

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
5 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
5 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
7 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
8 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
9 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
10 hours ago
Lars olsen posted a blog post
18 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service