Bryan Pringle's Discussions (14)

Discussions Replied To (12) Replies Latest Activity

"Funny you mention his name. I have not run this exact plan by him, but I had the opp…"

Bryan Pringle replied May 5 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"Vapor barrier is happening regardless, but I have a choice as to whether I use even…"

Bryan Pringle replied May 1 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"Thanks Norm, we'll have a couple of case studies when all is said and done. Just cu…"

Bryan Pringle replied Apr 23 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"Can you tell me more about how the plastic makes the moisture worse?   I understand…"

Bryan Pringle replied Apr 20 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"I like cellulose because of its air leakage reduction property and the ease of makin…"

Bryan Pringle replied Apr 20 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"This example is the reverse of my suggestion.  I would do high end vapor barrier aga…"

Bryan Pringle replied Apr 20 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"In short, it isn't foam. So I want to learn if it is possible"

Bryan Pringle replied Apr 20 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"I am getting a lot of "bad idea" push back on this.  I fully understand that convent…"

Bryan Pringle replied Apr 18 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"Thanks, I appreciate the thoughts.  With that in mind, I may consider a high perform…"

Bryan Pringle replied Apr 11 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

"This excerpt from the second article accurately describes my vapor barrier assembly…"

Bryan Pringle replied Apr 11 to Dense packed cellulose in basement?

31 May 5
Reply by Bryan Pringle

RSS

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
7 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
7 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
10 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
11 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
12 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
13 hours ago
Lars olsen posted a blog post
20 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service