Using PHPP in Passive House Design and Certification

Event Details

Using PHPP in Passive House Design and Certification

Time: June 6, 2014 at 9am to June 7, 2014 at 4:30pm
Location: Vermont Energy Investment Corporation,
Street: 128 Lakeside Avenue, Suite 401,
City/Town: Burlington, VT 05401
Website or Map: http://www.passivehouse.ca/us…
Phone: andrew@passivehouse.ca
Event Type: course
Organized By: Andrew Peel
Latest Activity: May 19, 2014

Export to Outlook or iCal (.ics)

Event Description

In this two-day course, participants will learn how to use the PHPP for residential building design and certification.  Participants will be guided step-by-step through the relevant worksheets, while learning the correct conventions for measurements and calculations.  Proper documentation will also covered in detail.  A case study will provide participants with practical experience in completing and documenting PHPP calculations for building certification.

Learning Objectives:

1.Learn the structure, inputs, outputs, and measurement conventions of PHPP software
2.Assess building heat loss, energy demand and summertime overheating risk using PHPP
3.Understand how to properly prepare documentation and PHPP calculations for Passive House certification
4.Gain practical experience in completing a PHPP assessment for a residential  development

Comment Wall

Comment

RSVP for Using PHPP in Passive House Design and Certification to add comments!

Join Home Energy Pros

Attending (1)

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Mariusz Chorazy posted a blog post

Here are a few tips to keep your air conditioning bill low

TAKE GOOD CARE OF YOUR AIR CONDITIONER – Like any major appliance, your AC requires regular…See More
20 minutes ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Morgan, I got this below from the Knight installation manual. I note a few things, -These…"
2 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
16 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
17 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
19 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
20 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
21 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
22 hours ago

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service