Installation of Geothermal Heating and Cooling Systems

Event Details

Installation of Geothermal Heating and Cooling Systems

Time: February 3, 2011 from 7:30am to 4pm
Location: Chula Vista Resort
Street: 2501 North River Road
City/Town: Wisconsin Dells, WI 53965
Website or Map: http://www.ecw.org/university…
Phone: 608.238.8276 x135
Event Type: residential, training
Organized By: Energy Center University
Latest Activity: Jan 5, 2011

Export to Outlook or iCal (.ics)

Event Description

Heating, cooling and water heating make up the greatestenergy load in a building. Geothermal energy systems canefficiently address these energy loads in both residential andcommercial projects. In order to achieve maximum efficiency,however, it is important to design and install the entire systemcorrectly.

We'll cover water to air systems for space conditioning; water to water systems for domestic water heating, pool heating, radiant floor heating or other hydronic heating and cooling requirements; and split geothermal/dual fuel systems for space conditioning.

Learn about the different types of ground loop systems and their installation using International Ground Source Heat Pump Association (IGSHPA) standards, software programs to do the loop design and calculate potential energy savings, AHRI rating process and start up/commissioning of the system.

Comment Wall

Comment

RSVP for Installation of Geothermal Heating and Cooling Systems to add comments!

Join Home Energy Pros

Attending (1)

Home Energy Pros

Home Energy Pros was founded by the developers of Home Energy Saver Pro (sponsored by the U.S. Department of Energy,) and brought to you in partnership with Home Energy magazine.  Home Energy Pros is sponsored by the Better Buildings Residential Network.

Latest Activity

Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Hans, The car manufacturer's are doing it with mass flow sensors and oxygen sensors…"
7 hours ago
Dale Pickard replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I was trying to avoid naming manufacturers, but I was going by the published information for the…"
7 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"I look at this not about AFUE,  but flue gas dewpoint.  If your burn rate is rotting the…"
10 hours ago
Bob Blanchette replied to Kirsten Richnavsky's discussion Crawl spaces and attics: OSHA to implement new rule on confined spaces
"Keeping HVAC equipment out of attics should be part of the new code. "
11 hours ago
Linda Wigington replied to Linda Wigington's discussion Weigh in - Honorable Mention? 2nd Base? Half-Way There? 50% Better? On the Path? in the group 1000 Home Challenge
"Nickie -  Good points. I think it is easy enough to flag or designate projects that achieve…"
12 hours ago
Morgan M Audetat replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"Though Viessmann is relatively unique in the application of Lambda technology to condensing…"
13 hours ago
Lars olsen posted a blog post
20 hours ago
Eric Kjelshus replied to Rod Fox's discussion Does altitude affect AFUE? or just the input/output BTUs?
"The heat exchanger gets burnt out, if presser is to high or if mix is to rich, then I see holes in…"
yesterday

© 2015   Created by Lawrence Berkeley National Laboratory.

Badges  |  Report an Issue  |  Terms of Service